Adding a New Tenant Placeholder

You can add a new tenant placeholder.

➢

To add a new tenant placeholder:

1.

Open the Tenant Configuration page (Setup > Configuration > Tenant Configuration).

2.

Under Tenant Configuration, provision devices using the 'Configuration Set' parameter and the corresponding 'Configuration Key' and 'Configuration Value' parameters that are auto-populated after selecting a device model.

●

On the right side of the page, click the vertical ellipsis ⋮ and from the menu that pops up shown in the preceding figure, select DST for IGS/SFB or DST for Teams and then select AUTO, ENABLE or DISABLE. This menu provides a quick and friendly way to configure Daylight Saving Time (DST) for Generic SIP / Skype for Business phones and for Native Teams phones.

3.

Under the lowermost Tenant Placeholders section of the page, click the +Add New Placeholder button.

4.

In the 'Name' field, enter / select the name of the new placeholder.

5.

In the 'Value' field, enter the value of the new placeholder.

6.

From the 'Tenant' dropdown, select a new tenant.

7.

Click Save; the new placeholder is added to the table.